GearWall Mounting Plate for the EGO Rapid Charger: Get It Off the Bench and On to the Wall
Out of the box, the CH5500 hangs from two small holes in its own housing, which means drilling into your wall and committing to that spot forever. This plate snaps into the track system you already own. The charger slides down onto the backing plate and seats into place, then reinforcing brackets underneath carry the load from below instead of leaving it to hang.
Built for the Wall System You Already Own
- Engineered for Gladiator Panels: Designed to snap cleanly into GearWall panels for a secure, flush fit.
- Installs in Seconds: Snap the plate into your existing track and slide the charger on. No drilling, no screws, no anchors, no hassle.
- Reposition Anytime: Slide your charging station along the channel as your wall layout changes or your battery collection grows.
Engineered to Carry the Weight
- Slide On and Seated: The charger slides straight down onto the backing plate and locks into position. No adapters, no fiddling, no zip ties.
- Supported From Underneath: Reinforcing brackets sit beneath the charger and carry the load in compression, which is exactly where plastic is strongest.
- Ready for the Heaviest Packs: EGO normally rates a loaded charger and battery at up to 10.6 lbs, this is designed to take well over double that. This plate is built and braced to carry it without sag or creep.
- Tough Construction: Printed in ABS, a durable engineering-grade plastic that holds up to demanding garage, workshop, shed, and contractor trailer conditions.
Key Benefits
- Reclaim Your Bench: A charger and a battery take up real estate you would rather use for work. Put them on the wall and get the surface back.
- Fills the Gap in Your System: Gladiator makes a hook for almost everything except this. Now your charger has a place in the system too.
- Charge Where You Store: Set your charging station right beside your battery mounts so the whole system lives on one wall.
- Clean, Finished Look: A charger sitting square and level on a proper plate looks like it belongs there, because it does.
Fitment
-
Fits: EGO Power+ rapid chargers — CH5500, CH5500A.
-
Does not fit: CH2100 / CH3200 standard chargers.
Built from Professional Grade ABS, Not hobbyist PLA or PETG
- Printed in ABS, the engineering thermoplastic used for power tool housings. It stays rigid when it gets hot.
- Most 3D printed mounts sold today are PETG, a hobby-grade filament. In a hot garage, shed, or trailer, PETG softens under the sustained weight of a hanging tool.
- The failure is quiet. Nothing cracks and nothing snaps, so you get no warning — you just walk in one day and find your trimmer on the concrete.
- ABS is what you use when the tool on the hook costs more than the hook.
* Designed to fit standard Gladiator GearWall systems. This product is not compatible with Gladiator GearTrack (due to product height), standard SlatWall, or ProSlat systems. Reach out and we will work with you to verify fit.
Need it for standard PVC slatwall? Get the SlatWall version here.
** Mount is not an EGO or Gladiator product and PartForge is not affiliated with, endorsed by, or sponsored by either. GearWall are trademarks of their respective owner and are used only to describe compatibility. The charger and batteries are shown for demonstration purposes only and are not included.
